TM 9-2320-279-20-2
16-130.4
Change 4
Cab and Body Maintenance Instructions (Cont)
16-32.1 THREE-POINT SEATBELT REMOVAL/INSTALLATION (MODEL A) (CONT).
c. Installation.
(1)
Install retractor (1) with screw (2),
washer (3), and locknut (4) to cab (5).
NOTE
·
Make sure belt is not twisted and is
centered in windshield washer
bracket. Belt must move freely
between bracket and installed
windshield washer reservoir.
·
Comfort latch must be mounted
vertically in line with belt, hang
directly below D-loop mounting, and
remain rigid after tightening.
·
D-loop and plastic washers must
move freely after screw is tightened
and when belt is removed and
retracted.
(2)
Install D-loop (6) with screw (7), two
washers (8), washer (9), and locknut (10) to
cab (5). Tighten to 70 to 75 lb-in (8 NSm).
(2.1) Install cap (10.1) on screw (7).
NOTE
·
Belt end and tether must be just free
to rotate after nut is tightened.
·
Tether must be positioned 45_
rearward and downward.
(3)
Install belt end (11) and tether (12) on
seat (13) with screw (14), washer (15),
and locknut (16). Tighten to 40 lb-ft
(54 NSm).
(4)
Install other end of tether (12) with
washer (17) and screw (18) to cab (5).
