TM 5-5420-234-14&P
5-4.
BAP WINCH REPAIR (continued).
j.
Brake Hub Subassembly Assembly.
(1) Install bearing (19) in brake hub (18), making sure bearing (19) lip end goes into recessed side of brake
hub (18).
(2) Install two clutch liners (17) on brake hub (18), with recessed sides inward.
(3) Install raised side of brake hub (18) on nonsplined end of motor drive shaft (16), turning motor drive shaft
(16) counterclockwise until brake hub (18) fits securely on motor drive shaft (16).
WARNING
Wear safety goggles and use care when installing snapring. It is under spring tension
and can act as a projectile when released. Failure to heed this warning can result in
serious injury to personnel.
(4) Install snapring (15) on machine-cut groove in nonsplined end of motor drive shaft (16).
(5) Install two bearing seats (22) and bearing (23) on motor drive shaft (16).
WARNING
Wear safety goggles and use care when installing retaining ring. It is under spring
tension and can act as a projectile when released. Failure to heed this warning can
result in serious injury to personnel.
(6) Install retaining ring (20) and C-clip (21) on machine-cut grooves in splined end of motor drive shaft (16).
21
23
20
16
22
17
18
19
17
15
5-66
