TM 5-5420-234-14&P
5-4.
BAP WINCH REPAIR (continued).
a. Brake Hub Assembly Removal.
(1) Remove pipe plug (1) from motor adapter (2).
CAUTION
Brake springs are under pressure inside motor housing. Remove motor adapter screws
one turn at a time, until spring pressure has been released.
NOTE
Match-mark motor adapter and its location on the winch so motor adapter can be
installed at the same angle as when removed.
(2) Remove four screws (3) and lockwashers (4) and motor adapter (2) from brake housing (5). Discard
(3) Remove O-ring (6) from motor adapter (2). Discard O-ring.
(4) Remove six springs (7) from piston (8).
(5) Remove piston (8) from brake housing (5).
(6) Remove two O-rings (9 and 10) from piston (8). Discard O-rings.
(7) Remove brake hub subassembly (11) from brake housing (5).
5
(8) Remove seven spacer plates (12), six
brake spacer plates (13), and brake
12
spacer (14) from brake housing (5).
14
11
13
7
10
9
8
1
6
3
2
4
5-57
