TM 5-5420-234-14&P
4-85. MAIN JUNCTION BOX HARNESS (FRONT) REPLACEMENT (MODEL A ONLY)
(continued).
NOTE
Tag and mark wires prior to removal.
(3) Remove wire no. 30 (4) from terminal no. 30 (5), wire no. 29 (6) from terminal no. 29 (7), wire no. 6
(8) from terminal no. 6 (9) and wire no. 31 (10) from terminal no. 31 (11).
(4) Remove wire no. 6 (12) from terminal no. 6 (9), wire no. 5 (13) from terminal no. 5 (14) and wire no. 9
(15) from terminal no. 9 (16).
(5) Disconnect connector P3 (17) from main junction box harness (18).
(6) Remove four locknuts (19) and screws (20) from main junction box harness (18). Discard locknuts.
(7) Remove main junction box harness (18) from junction box (21).
20
8
21
14
13
15
9
16
17
12
18
6
19
10
7
11
4
OTHER WIRE HARNESSES
5
REMOVED FOR CLARITY
b. Installation.
WARNING
Adhesives, solvents and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin. To avoid injury or death, keep away from open fire
and use in well ventilated area. If adhesives, solvent or sealing compound gets on skin
or clothing, wash immediately with soap and water.
NOTE
Connector should be installed with notch facing up.
(1) Apply RTV sealant adhesive to flange of main junction box harness (18) and install in junction box (21)
with four screws (20) and new locknuts (19).
4--638
4 63
Change 1