TM 5-5420-234-14&P
4-84. MAIN JUNCTION BOX HARNESS (24-PIN) REPLACEMENT (MODEL A ONLY)
(continued).
(7) Remove connector P4 (38) from main junction box harness (39).
(8) Remove four locknuts (40), and screws (41), and main junction box harness (39) from main junction box
(42). Discard locknuts.
b. Installation.
WARNING
Adhesives, solvents and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin. To avoid injury or death, keep away from open fire
and use in well ventilated area. If adhesives, solvent or sealing compound gets on skin
or clothing, wash immediately with soap and water.
NOTE
Connector should be installed in junction box with notch facing up.
(1) Apply RTV sealant adhesive to flange of main junction box harness (39) and install in junction box (42)
with four screws (41) and new locknuts (40).
(2) Install connector P4 (38) on main junction box harness (39).
(3) Install wire no. 4 (36) on terminal no. 4 (37), wire no. 27 (34) on terminal no. 27 (35), wire no. 36 (32)
on terminal no. 36 (33), wire no. 1 (30) on terminal no. 1 (31) and wire no. 10 (28) on terminal no. 10
(29).
(4) Install wire no. 8 (26) on terminal no. 8 (27), wire no. 12 (24) on terminal no. 12 (25), wire no. 11 (22)
on terminal no. 11 (23) and wire no. 17 (20) on terminal no. 17 (21).
22
29
21
37 36
42
23
24
27
25
30
20
38
39
31
26
28
41
34
33
35
40
OTHER WIRES REMOVED FOR CLARITY
32
446635
- - 35
Change 1
