TM 5-5420-234-14&P
4-79. HOOK ARM VALVE (UNLOAD) HARNESS REPLACEMENT (MODEL A ONLY)
(continued).
(7) Loosen screw (16) and remove connector (17) and gasket (18) from directional control valve (19).
Discard gasket.
19
18
17
16
(8) Remove nut (12), plastic insert (13), and rubber grommet (14) from hook arm valve (unload) harness
(15).
b. Installation.
NOTE
Install cable ties as required.
Ensure rubber grommet is installed in same position as noted during removal.
(1) Install rubber grommet (14), plastic insert (13), and nut (12) on hook arm valve (unload) harness (15).
(2) Install new gasket (18) and connector (17) to directional control valve (19) and tighten screw (16).
(3) Position hook arm valve (unload) harness (15) in junction box (11).
4-617
Change 1
