TM 5-5420-234-14&P
This task covers:
a.
Inspection
b. Installation
c.
Follow-on Maintenance
INITIAL SETUP
Tools and Special Tools
Equipment Condition
Tool Kit, General Mechanic's: Automotive
Load removed from the BAP (para 2-12)
(SC 5180-90-N26)
BAP unloaded from the CBT (para 2-10)
NOTE
Do not remove tube nuts and flared tube sleeves from air tubing unless there is
leakage or other damage to tubes, tube nuts, or flared tube sleeves that make them
unserviceable.
If flared tube sleeve is removed, inspect end of tube connected by tube nut for
distortion or other damage that would make it unserviceable. Do not reuse flared
tube sleeves.
All tube nuts and flared tube sleeves are replaced in the same manner. Use the
following procedure to replace all tube nuts and flared tube sleeves.
a. Inspection.
Inspect end of tube (1) for distortion or other damage. If distortion or damage is noted, replace tube (1).
1
