TM 5-5420-234-14&P
NOTE
Manual mode operations using the cab control box are to be performed only
when the normal AUTO SEQUENCE mode electric circuit is not operating.
This procedure is used to remove the load from a Transporter with a failed
hydraulic system or other failure that prevents operation of the hydraulic
system.
Each Transporter is equipped with one hose. Two hoses (one from each
vehicle) are required.
a. Move vehicles into position so LHS control boxes on both vehicles are side by side.
b. Shut off engines on both vehicles.
c.
Disconnect hydraulic lines on both vehicles at quick disconnect located just forward of workstation behind
engine.
NOTE
Make sure to connect disabled vehicle' s female end of slave hose to rigid mounted
male end of supply hose on disabled vehicle and to connect male end of disabled
vehicle' s slave hose to rigid mounted female end of return hose on disabled vehicle.
d. Connect disabled vehicle's male end of slave hose (1) to hose-mounted female end of supply hose (2) on
operable vehicle.
2
1
4
OPERABLE VEHICLE
3
