TM 5-5420-234-14&P
2-29. MANUALLY BYPASSING SOLENOID DURING ELECTRIC POWER LOSS
(continued).
c.
Refer to and perform the appropriate operational procedures with the following exceptions: When the
procedure directs the operation of the remote control unit or the cab controls, use the manual valve plunger
tool (6), follow the placard (2), and perform the operation within the control valve layout of the hydraulic
manifold assembly. Fit plunger tool (6) in appropriate hole in hydraulic manifold assembly (7) and press
plunger tool (6) into solenoid button (8).
6
8
7
WARNING
Do not lift a load greater than the rated load capacity of the crane or materiel-
handling equipment. Failure to heed this warning could result in death or injury
to personnel or damage to equipment.
CAUTION
The main frame of the LHS must be in fully stowed position. Attempting to lift
the BAP with main frame not stowed could result in damage to equipment.
NOTE
Manual mode operations using the cab control box are to be performed only
when the normal AUTO mode electric circuit is malfunctioning.
This procedure is performed when a loaded BAP must be removed using a crane
or other handling system and must be done with the help of a higher maintenance
level.
The BAP weighs 5,810 pounds (2,637 kg). The BAP with bridge bay weighs
24,148 pounds (10,963 kg).
a. Make sure main frame is fully stowed.
b. Make sure that, if necessary, main frame is lowered using loading button of the solenoid bypass procedure as
necessary (para 2-29).
