TM 5-5420-234-14&P
2-12. UNLOADING BRIDGE BAY TO THE GROUND (continued).
WARNING
After releasing rear guides, only the winch hook secures bridge bay to the BAP.
Personnel must not mount the BAP and must stay clear of the area around rear of
Transporter. The load could shift, release, or fall, resulting in death or injury to
personnel.
19
k. Set curb-side and road-side rear guides (19) to full open
position:
(1)
Rotate latch pin (20) until rear guide (19) disengages.
(2)
Swing rear guide (19) until pin (21) clicks into hole.
21
20
l.
Position HOOK ARM switch (22) to UNLOAD and release when hook arm cylinders (23) are extended
approximately 6 inches (15 cm).
CAUTION
While moving LHS hook arm rearward, make sure winch hydraulic hose lines are
not trapped or damaged.
m . Position HIGH IDLE switch (24) to ON.
n. Position MAIN FRAME switch (25) to UNLOAD.
es
ch )
in
6 5 cm
24
(1
23
25
22
2-59
