TM 9-2320-279-34-2
Suspension Maintenance Instructions (Cont)
14-6.1. EQUALIZER BEAM ASSEMBLY (REAR TANDEM) (MODEL 650)
REMOVAL/INSTALLATION (M984E1).
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
M984E1
TM o r Para
Condition Description
Test Equipment
Para 10-2.1
Axle No. 3 (Axle Model 650)
None
removed.
Special Tools
Para 10-3.1
Axle No. 4 (Axle Model 650)
removed.
None
Special Enviromental Conditions
Supplies
None
Oil Lubricating, Item 46, Appendix C
General Safety Instructions
Personnel Required
Front Wheels chocked
MOS 63W, Wheel vehicle repairer (2)
Level Of Maintenance
References
Direct Support
None
a.
l
l
Removal.
NOTE
Removal steps are the same for both
sides. Left side shown.
Support equalizer beams with suitable
lifting device.
(1) Remove four nuts (1), washer (2) and
saddle caps (3) from both sides of
vehicle.
(2) Solder A and Soldier B lower lifting
device and remove equalizer
beams (4) from vehicle.
14-23
