TM 9-2320-279-34-3
Special Purpose Kit Installation Instructions (Cont)
(24)
(25)
Install wire harness (25) in two cushion
clips (50). Install two screws (51) with two
washers (52), 8-in. (203 mm) ground
wire (34), cushion clips, lockwashers (53), and
nuts (54).
Install filter (55) and tighten clamps (56).
Adhesives, solvents, and sealing
compounds can burn easily, can give off
harmful vapors, and are harmful to skin
and clothing. To avoid injury or death,
keep away from open fire and use in
well-ventilated area. If adhesive, solvent,
or sealing compound gets on skin or
clothing, wash immediately with soap and
water.
(26) Apply pipe thread sealing compound and
install two plugs (57).
(27) Apply pipe thread sealing compound and
install two fittings (58).
(28) Repeat steps (26) and (27) for right
heater.
23-45
