TM 9-2320-279-34-2
Change 4
16-71
Winch Maintenance Instructions (Cont)
d. Assembly.
(1)
Install lip seal (1), back-up ring (2), snap ring (3), and dust seal (4) in body bearing assembly (5).
(2)
Install shaft (6) in body bearing assembly (5).
(3)
Install preformed packing (6.1) on body bearing assembly (5).
NOTE
•
T-shaped slots face down on shaft spline.
•
Roll pockets on inner geroler go between valve ports.
(4)
Install commutator plate (6.2), rotary valve (6.3), inner geroler (7), and retaining ring (8) on shaft
(6).
NOTE
Short rollers are installed in ring. Long rollers are installed in geroler.
(5)
Install seven rollers (9) on inner geroler (7).
(6)
Install outer geroler (10) on rotary valve (6.3).
(7)
Install preformed packing (11) in body bearing assembly (5).
(8)
Install two balls (12) in small holes of IGR assembly (13).
(9)
Aline matchmarks and install IGR assembly (13) and eight rollers (14).
