TM 9-2320-279-34-2
Frame Maintenance Instructions (Cont)
NOTE
Left and right rear mud flap and bracket assemblies
are installed in a similar manner.
(20) Install mounting bar and mud flap assembly (47).
(22) Install cotter pin (48).
(22) Tighten two screws (49) and nuts (50).
(23) Remove lifting device.
c. Follow-on Maintenance.
(1) Install rear composite light assemblies
(TM 9-2320-279-20).
(2) Install tow bar (TM 9-2320-354-10).
END OF TASK
13-24.1. REAR CROSSMEMBER REMOVAL/lNSTALLATlON (M984E1).
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
Equipment Condition
M984E1
TM or Para
Condition Description
Test Equipment
Para 13-30.3
Retriever lift cylinder
None
removed.
Para 13-30.5
Retriever tow cylinders and
Special Tools
pivot brackets removed.
None
TM 9-2320-279-20 Pintle hitch removed.
Supplies
NOTE
None
For ease of removal and
Personnel Required
installation, the following
MOS 63W, Wheel vehicle repairer (2)
equipment condition may be
used, but is not necessary.
References
TM 9-2320-279-10
Wheels and tires removed
None
from No. 4 axle.
Equipment Condition
Special Environmental Conditions
TM or Para
Condition Description
None
TM 9-2320-279-10
Towing shackles removed
from rear of vehicle.
General Safety Instruction
Para 16-10.3
Fairlead tensioner removed.
None
TM 9-2320-279-20 Mudflap mounting brackets
Level of Maintenance
removed.
TM 9-2320-279-20
Rear fenders removed.
Direct Support
13-76.1
