TM 9-2320-279-34-2
Axles No. 3 and No. 4 Maintenance Instructions (Cont)
10-12. DIFFERENTIAL CARRIER, AXLE NO. 4 (AXLE MODELS 480 AND 580) REPAIR
(CONT).
(51)
(52)
(53)
(54)
(55)
(56)
(57’)
(58)
(59)
(60)
(61)
Remove pinion (36) from bearing cage (29).
Remove outer bearing cone (34) and spacer (33).
Install pinion (36) in bearing cage (29).
Use 0.001 -in. (0.03 mm) thicker spacer (33) and install spacer and
outer bearing cone (34) on pinion (36).
Repeat steps (47) through (50).
Remove pinion (36) from bearing cage (29).
Remove outer bearing cone (34) and spacer (33).
Install pinion (36) in bearing cage (29).
Use 0.001-in. (0.03 mm) thinner spacer (33) and install spacer and
outer bearing cone (34) on pinion (36).
Repeat steps (47) through (50).
Install oil seal (39), yoke (37), and locknut (38) on pinion (36). Tighten
locknut to 840 to 1020 lb-ft (1 139 to 1383 N·m).
WARNING
Adhesives, solvents, and sealing compounds can burn
easily, can give off harmful vapors, and are harmful to
skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If
adhesive, solvent, or sealing compound gets on skin or
clothing, wash immediately with soap and water.
(62) Apply sealing compound to flange of cage (29) and
differential carrier (2).
NOTE
If gear set is reused, install same size shim pack as
removed. If new gasket is used, install 0.023-in.
(0.6 mm) shim pack.
(63) Install shims (40) on differential carrier (2).
(64) Aline matchmarks and install bearing cage (29) on
differential carrier (2).
10-80
