TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
9 - 1 0 .
DIFFERENTIAL CARRIER, AXLE NO. 2 REMOVAL/INSTALLATION (CONT.).
a.
Removal.
.
.
(1)
(2)
(3)
NOTE
There are two models of axle
housings: Model A and Model B. The
differential carrier is mounted on
Model A housing by two screws and
10 studs and nuts. The differential
carrier is mounted on Model B
housing by eight screws and four
studs and nuts.
Do steps (1) through (3) and (4)
through (6) for Model A housing. Do
steps (1) and (3.1) through (6) for
Model B housing.
Remove two screws (1), lockwashers (2),
and bracket (3) from differential
carrier (4).
Remove 10 nuts (5), lockwashers (6), and
two brackets (7).
Mark location and remove four tapered dowels (8).
(3.1) Remove four nuts (5), lockwashers (6), and tapered dowels (8) from differential carrier.
(3.2) Remove six screws (1), lockwashers (2), and two brackets (7).
WARNING
Keep out from under differential carrier. Serious injury may result if differential
carrier falls from lifting device.
CAUTION
Do not strike differential carrier to loosen. Tap around edge of flange to avoid
damage.
(4)
Attach lifting device to differential carrier (4).
(5)
Soldier A removes differential carrier (4) while Soldier B operates lifting device.
(6)
Mount differential carrier (4) on stand
and fasten in place. Remove lifting
device.
9-36 Change 3
