(28)
(29)
TM 9-2320-279-34-1
Axles No. 1 and No. 2 Maintenance Instructions (Cont)
Tighten locknut (16) to 35 to
45 lb-ft (47 to 61 Nm).
install D-washer (46) and thrust
washer (47) on input shaft (33).
W A R N I N G
Wear safety glasses while installing
retaining rings to protect eyes from
possible injury or blindness.
(30)
Install helical side gear (35) and
retaining ring (48) on input
shaft (33).
d. Follow-on Maintanance. None.
END OF TASK
9-10.
DIFFERENTIAL CARRIER, AXLE NO. 2 REMOVAL/lNSTALLATlON.
This task covers:
a. Removal
b. Cleaning/Inspection
c. Installation
d. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Special Tools
None
Supplies
Solvent, dry cleaning, Item 57, Appendix C
Adhesive-sealant, silicone, Item 6, Appendix C
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
References
None
Equipment Condition
TM or Para
Condition Description
Para 9-4
Axle No. 2 removed.
Para 9-5
Axle housing cover assembly,
No. 2 removed.
Para 9-8
Differential carrier cover
removed.
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
General Support
9-35
