TM 9-2320-279-34-1
7-68
Change 5
Transmission Maintenance Instructions (cont)
7-9. TORQUE CONVERTER HOUSING REMOVAL/REPAIR/INSTALLATION (CONT).
NOTE
Nine screws and lockwashers are used to install
torque converter housing on transmission housing.
Two screws and lockwashers must be installed after
lifting eyes are removed.
(18)
Install seven screws (17) and lockwashers
(18) to hold torque converter housing (11) to
transmission housing (12). Tighten screws
to 67 to 80 lb-ft (91 to 108 NSm).
f. Follow- on Maintenance. Install torque converter
pump in torque converter housing (para 7-8).
END OF TASK
Supplies
Solvent, drycleaning, Item 57, Appendix C
Compound, sealing, lubricating,
Item 25, Appendix C
This task covers:
a. Disassembly
c. Assembly
b. Cleaning/Inspection
d. Follow-on Maintenance
INITIAL SETUP
Personnel Required
MOS 63W, Wheel vehicle repairer
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-20 Transmission breather
removed.
TM 9-2320-279-20 Neutral safety switch
removed.
Para 7-16
Rear cover and first
clutch assembly
removed.
Para 7-13
Gear unit and main
shaft assembly
removed.
References
None
Special Tools
Manual shaft oil seal installer J26282
Manual shaft oil seal remover J26401
7-10. TRANSMISSION HOUSING REPAIR.
Models
All
Test Equipment
None
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
General Support
