TM 9-2320-279-34-1
Change 5
7-71
Transmission Maintenance Instructions (Cont)
(2)
Install reverse signal switch plug (2).
(3)
Install fourth clutch pressure tap
plug (3).
(4)
Install governor pressure tap plug (4).
WARNING
Adhesives, solvents, and sealing compounds can
burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or
death, keep away from open fire and use in
well-ventilated area. If adhesive, solvent, or
sealing compound gets on skin or clothing, wash
immediately with soap and water.
(5)
Coat outside of oil seal (5) with sealing
and lubricating compound and install
oil seal in transmission housing (6)
using manual shaft oil seal installer.
(6)
Position detent lever (7) in transmission
housing (6) with selector pin pointing to
inside of housing.
(7)
Install manual shaft (8) by pushing
shaft through oil seal (5) in
transmission housing (6) and slot in
detent lever (7).
(8)
Install locknut (9) on manual shaft (8).
(9)
Tighten locknut (9) to 15 to 20 lb-ft (20
to 27 NSm).
(10)
Install cotter pin (10).
