TM 9-2320-279-34-1
6-124 Change 5
Electrical System Maintenance Instructions (Cont)
6-16. CHASSIS/ENGINE WIRING HARNESS REMOVAL/INSTALLATION (CONT).
NOTE
Three clips attach chassis/engine harness to
frame. All clips are installed to frame the
same way.
(3)
Attach chassis/engine harness (7) to frame (8)
with clip (9), screw (10), washer (11),
lockwasher (12), and nut (13).
(4)
Route chassis/engine harness (7) through
frame (8) and up under cab floor (14).
Bundle harness (15) to chassis/engine
harness with plastic cable ties along
length of harness.
NOTE
Connectors are keyed to fit proper receptacles
only.
(5)
Connect two plug connectors (16 and 17) to two
receptacles (18 and 19) under cab floor (14).
NOTE
·
Install clamps, cushion clips, and
plastic ties as necessary.
·
Do step (6) for M978 only if equipped
with high mount stop light.
(6)
Connect connector (20) to connector (21).
c. Follow-on Maintenance.
(1)
Install skid plate grille (TM 9-2320-279-20).
(2)
Connect batteries (TM 9-2320-279-20).
(3)
Start engine, check vehicle operation
(TM 9-2320-279-10).
END OF TASK