TM 9-2320-279-34-1
Change 5
6-122.13/(6-122.14 blank)
Electrical System Maintenance (Cont)
Supplies
Tags, identification, Item 60, Appendix C
Ties, cable, plastic, Item 65, Appendix C
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Personnel Required
MOS 63W, Wheel vehicle repairer
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-20 Batteries disconnected.
TM 9-2320-279-20 Skid plate grille removed.
References
None
Special Tools
None
6-16. CHASSIS/ENGINE WIRING HARNESS REMOVAL/INSTALLATION.
Models
All except M984E1
Test Equipment
None
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
Direct Support
a. Removal.
NOTE
·
Tag and mark all wires and connectors.
·
Remove clamps, cushion clips, and plastic ties as necessary.
·
Cushion clips are returned to same positions after section of chassis/engine wire
harness is removed.
·
Do step (1) for M978 only if equipped with high mount stop light.
(1)
Disconnect connector (1) from connector (1.1).
(1.1) Remove two plug connectors (1.2 and 2) from receptacles (3 and 4) under cab floor (5).
