TM 9-2320-279-34-1
Change 5
6-87
Electrical System Maintenance Instructions (Cont)
(50)
Install two heater
compartment covers (115)
on console (2) with 11
screws (116).
(51)
Install heater compartment
cover (117) with eight
screws (118).
c. Follow-on Maintenance.
(1)
Install ETHER START
switch (TM 9-2320--279-20).
(2)
Install starter switch
(TM 9-2320--279-20).
(3)
Install TRACTION
CONTROL switch
(TM 9-2320--279-20).
(4)
Install ENGINE STOP switch
(TM 9-2320--279-20).
(5)
Install TRACTION
CONTROL indicator light (TM 9-2320--279-20).
(6)
Install instrument panel (TM 9-2320--279-20).
(7)
Connect batteries (TM 9-2320--279-20).
END OF TASK
Supplies
Connector, electrical butt, Item 31,
Appendix C
Sealant, RTV200 Electrical, Item 55.2,
Appendix C
Tags, identification, Item 60, Appendix C
Tape, insulation, electrical, Item 62,
Appendix C
Ties, cable, plastic, Item 65, Appendix C
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Personnel Required
MOS 63W, Wheel vehicle repairer
Equipment Condition
TM or Para
Condition Description
TM 9-2320-279-20 Batteries disconnected.
References
None
Special Tools
None
6-14. ENGINE WIRING HARNESS REMOVAL/INSTALLATION.
Models
All
Test Equipment
None
Special Environmental Conditions
None
General Safety Instructions
None
Level of Maintenance
Direct Support
