TM 9-2320-279-20-3
Filter-Separator Maintenance Instructions (Cont)
(4)
Soldier A installs and holds screw (11) in filter-separator (10) and bracket (12) while Soldier B
installs but does not tighten locknut (13).
NOTE
Do not tear or otherwise damage coupling gaskets during installation. If coupling
gaskets are damaged, piping connections will leak.
Do not pinch or pull coupling gaskets off-center while installing coupling halves. If
coupling gaskets are damaged or out of position, piping connections will leak.
(5)
Aline two pipes (3 and 4) with openings in filter-separator (10) and install two coupling
gaskets (1 and 2).
NOTE
Next coupling or clamp may have to be loosened before installation.
(6)
Install four coupling halves (14) on two coupling gaskets (1 and 2) with four screws (15) and
nuts (16).
(7)
Soldier A installs and holds two screws (17) in filter-separator (10) and brackets (8) while
Soldier B installs two locknuts (18).
(8)
Soldier A holds screw (11) while Soldier B tightens locknut (13).
Change 3
23-37
