TM 5-5420-234-14&P
5-14. COMPRESSION FRAME REPLACEMENT (continued).
WARNING
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in a well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
NOTE
Install spring washers in pairs with no two pairs in the same direction.
(12.1) Apply thread lock sealing compound to threads of two screws (8).
(13) With the aid of an assistant, install eight spring washers (9), two front screws (8), four washers (7), and new
locknuts (6) in compression frame (5). Tighten locknuts to 75 lb-ft (102 Nm).
(14) Repeat Steps 12 through 13 for right side of vehicle (12).
(15) Remove lifting device from compression frame (5).
(16) Install ground strap (3) on frame (4) and
compression frame (5) with two screws
10480
(2) and new locknuts (1).
c. Follow-on Maintenance:
Install main manifold support frame (para 5-15).
Install diverter manifold (para 5-24).
Install main frame (para 5-11).
Install rubber bumpers (para 4-58).
Install winch (compression frame) hydraulic tubes (para 5-19).
Install compression frame hydraulic hoses (para 5-17).
Install main LHS harness (para 4-86).
Install front BAP locks (para 4-57).
Change 3
5-105
