TM 5-5420-234-14&P
5-2. DIRECT SUPPORT TROUBLESHOOTING (continued).
7.
BAP WINCH DOES NOT OPERATE (continued).
3
BAP WINCH MOTOR TEST
1
7
(1)
Remove winch motor (1) from
housing (2) (para 4-40).
(2)
Reinstall winch motor (1) on two
5
tubes (3) with shaft (4) pointing
out and fitting (5) pointing down.
(3)
Install cap (6) on fitting (7).
(4)
If necessary, attach two quick-
disconnect hoses to Transporter.
6
(5)
Start engine.
(6)
Turn PTO ENGAGE switch (8) to
3
ON position.
2
NOTE
Oil will leak from hydraulic tub-
ing when the WINCH switch is
in the neutral position. Place
3
drain pan under tubing to col-
lect oil.
1
(7)
Move WINCH switch (9) to the
OUT position, then to the IN
position while observing the
4
winch shaft (4).
(8)
Turn PTO ENGAGE switch to
OFF position.
(9)
Shut off engine.
(10) Remove cap (6) from fitting (7).
(11) Remove winch motor (1) from
two tubes (2).
NOTE
If winch motor shaft failed to
rotate, skip Step 12.
(12) Install winch motor (1) on
housing (2) (para 4-40).
9
PTO ENGAGE
OFF
ON
8
5-49
