TM 5-5420-234-14&P
4-92. MAIN JUNCTION BOX HARNESS (REAR) REPLACEMENT (MODEL A ONLY)
(continued).
b. Installation.
WARNING
Adhesives, solvents and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin. To avoid injury or death, keep away from open fire
and use in well ventilated area. If adhesives, solvent or sealing compound gets on skin
or clothing, wash immediately with soap and water.
NOTE
Connector should be installed in junction box with notch facing up.
(1) Apply silicone RTV sealant adhesive to flange of main junction box harness (19) and install in junction
box (22) with four screws (21) and new locknuts (20).
(2) Install connector P6 (18) on main junction box harness (19).
(3) Install wire no. 2 (19) on terminal no. 2 (7), wire no. 12
(16) on terminal no. 12 (9), wire no. 3 (14) on terminal no.
18
3 (15) and wire no. 28 (12) on terminal no. 28 (13).
20
(4) Install wire no. 14 (10) on terminal no. 14 (11), wire no. 12
19
(8) on terminal no. 12 (9), wire no. 2 (6) on terminal no. 2
(7) and wire no. 29 (4) on terminal no. 29 (5).
9
11
14
10
15
16
17
21
7
6
22
8
4
12
5
13
4--660
4 658
Change 1
