TM 5-5420-234-14&P
4-76.
FREE FLOW VALVE HARNESS REPLACEMENT (MODEL A ONLY) (continued).
(7) Loosen screw (16) and remove connector (17)
and gasket (18) from free flow valve coil (19).
Discard gasket.
(8) Remove nut (12), plastic insert (13), and
rubber grommet (14) from free flow valve
harness (15).
16
HIDDEN
b. Installation.
17
18
NOTE
15
19
Ensure rubber grommet is installed in same
1
position as noted during removal.
Install cable ties as required.
(1) Install rubber grommet (14), plastic insert (13), and nut (12)
on free flow valve harness (15).
2
(2) Install new gasket (18) and connector (17) to free flow valve
3
coil (19) and tighten screw (16).
(3) Position free flow valve harness (15) in junction box (11).
(4) Position rubber grommet (14) over free flow valve harness
(15) and install plastic insert (13) and nut (12).
(5) Install junction box (11) on vehicle (19) with four screws
(10), washers (9) and new locknuts (8).
5
7
(6) Install black wire no. 24 (6) on
terminal no. 24 (7) and white
wire no. 23 (4) on terminal no.
11
23 (5).
6
(7) Close junction box cover (3)
and tighten four screws (2).
4
(8) Close hydraulic cabinet cover
(1).
14
8
9
c. Follow-on Maintenance:
13
Connect batteries (TM 9-2320-
10
279-20).
15
12
END OF TASK
OTHER WIRE HARNESSES REMOVED FOR CLARITY
4--609
4 609
Change 1