TM 9-2320-279-34-2
Axles No. 3 and No. 4 Maintenance Instructions (Cont)
10-10. DIFFERENTIAL CARRIER, AXLE NO. 3 (AXLE MODELS 480, 580, AND 650) REPAIR
(CONT).
(96) If tooth contact is like pattern E, move pinion
away from ring gear (10) by adding shims, then
repeat steps (81) through (92).
(97) Tighten four screws evenly (49
and 52) to 370 to 430 1b-ft (502 to
583 N·m).
NOTE
Bearing adjuster may be turned slightly to
aline adjuster locks.
(98)
(99)
(100)
(101)
(102)
Install adjuster lock (56) and cotter
pin (57) on bearing cap (48).
Install lockwire on two screws (49).
Install adjuster lock (58) with two
screws (59). Tighten screws evenly
to 160 to 176 lb-ft (217 to 239 N·m).
Install lockwire on two screws (59).
Install lockwire on two screws (52).
10-58