Axles No. 3 and No. 4 Maintenance Instructions (Cont)
To add or remove shims in steps (95) and (96),
remove ring gear and differential assembly
(steps (3) through (14) in Disassembly) and pinion
(steps (33) through (36) in Disassembly). Add or
remove shims and install pinion. Remove ring gear
and differential assembly, steps (76.) through (94).
(95) If tooth contact is like pattern D, move pinion
closer to ring gear (10) by removing shims, then
repeat steps (81) through (92) .
· PATTERN TOO CLOSE TO EDGE
OF TOOTH TOE.