TM 9-2320-279-34-3
M977, M985, and M984E1 Crane Maintenance Instructions
17-5. TURNTABLE AND BEARING REMOVAL/INSTALLATION (CONT).
(9) Remove two dust seals (12) and grease
fitting (13) from bearing (10).
b. Installation.
NOTE
Ridge end of seal is installed
Cut off excess seal.
in bearing.
l
l
(1) Install two dust seals (1) and grease
fitting (2) in bearing (3).
NOTE
Letter G stamped on bearing faces
down and centered on subframe.
Replace turntable bearing bolts
with new bolts any time they are
removed.
(Cont)
(2) Aline and install bearing (3) on
subframe (4).
(3) Install 16 screws (5) and
washers (6).
17-24
