TM 9-2320-279-34-2
Axles No. 3 and No. 4 Maintenance Instructions (Cont)
10-7. DIFFERENTIAL CARRIER COVER, AXLE NO. 3 REMOVAL/REPAIR/INSTALLATION
(CONT).
(29)
(24)
(25)
(26)
(27)
(28)
(29)
Install bearing cup (35) in bearing cover (36) and apply sealing compound to bearing cover.
NOTE
Use recorded number of shims.
Aline holes in shims (37) with holes in bearing cover (36) and install five screws (38), bearing
cover, and shims on differential carrier cover (3). Tighten screws to 75 to 85 lb-ft (102 to
115 N•m) and apply sealing compound to outside diameter of bearing cover.
Install washer (39), yoke (40), washer (41), and locknut (42) on input shaft (31). Tighten locknut
finger-tight.
Tighten nut (13) to 35 to 45 lb-ft (47 to
61 N•m).
Install D-washer (43) on base of input
shaft (31 ) inside differential carrier
cover (3).
Install thrust washer (44) on input
shaft (31) against D-washer (43).
Lubricate bushings (32) and install
helical side gear (33) on input shaft (31).
Wear safety glasses to protect eyes from possible injury or blindness, while
installing retaining ring.
(30) Install retaining ring (45) on input shaft (31).
10-24
