TM 9-2320-279-34-2
Axles No. 3 and No. 4 Maintenance Instructions (Cont)
10-7. DIFFERENTIAL CARRIER COVER, AXLE NO. 3 REMOVAL/REPAIR/INSTALLATION
(CONT).
(10)
(11)
(12)
(13)
(14)
(15)
(16)
(17)
(18)
Install preformed packing (14) on piston (15).
Soak two felt oilers (16) in lubricating oil and install on piston (15).
Adhesives, solvents, and sealing compounds can burn easily, can give off harmful
vapors, and are harmful to skin and clothing. To avoid injury or death, keep away
from open fire and use in well-ventilated area. If adhesive, solvent, or sealing
compound gets on skin or clothing, wash immediately with soap and water.
Apply adhesive-sealant on differential carrier cover (3) around mounting hole and screw holes
for lockout body (17).
Install lockout body (17), two screws (18), and lockwashers (19) on differential carrier cover (3).
Tighten screws to 48 to 56 lb-ft (65 to 76 Nm).
Install lockout fork (20) through back side of differential carrier cover (3) in lockout body (17).
Do not install piston stop in lockout body on M984E1 (Model 650 axle).
Install piston stop (21) and spring (22) on lockout fork (20).
Push piston (15) against spring (22). Install preformed packing (23), washer (24), and nut (25) on
end of lockout fork (20). Tighten nut to 20 to 25 lb-ft (27 to 34 Nm).
Install preformed packing (26) in lockout
cover (27).
Install lockout cover (27), four screws (28), and
lockwashers (29) on lockout body (17). Tighten
screws to 105 lb-in (142 Nm).
10-22
