TM 9-2320-279-34-2
Cab and Body Maintenance Instructions (Cont)
15-13. PUMP MODULE REMOVAL/INSTALLATION (M978) (CONT).
CAUTION
Do not tear or otherwise damage coupling
gaskets during installation. If damaged
coupling gasket is used, piping connection will
leak.
(26)
Position coupling gasket (59) over
connections of pipes (60 and 61).
CAUTION
Do not pinch or pull coupling gasket off center
when coupling halves are installed. If gasket is
damaged or moved out of position, piping
connection will leak.
(27)
Install two coupling halves (62) on
coupling gasket (59) with two screws
(63) and nuts (641.
(28)
Install two screws (65) and nuts (66) in
left chassis rail (3).
(29)
Install two tubes (67 and 68) on elbows
(69 and 70) with nuts (71 and 72).
(30)
Connect three connectors (73, 74, and
75).
(31)
Install hose (76) on tank level sensor
(77) with nut (78).
C.
Follow-on Maintenance.
(3)
(3.1)
(4)
(5)
(6)
(7)
(8)
15-64
(1)
Connect batteries (TM 9-2320-279-20).
(2)
Install rear mud flaps and splash guards
(TM 9-2320-279-20).
Install rear cable guide
(TM 9-2320-279-20).
Install hose cover (TM 9-2320-279-20)
(for left side only) (some models only).
Start engine, build up air pressure
(TM 9-2320-279-10).
Install hard lift point access panel
(TM 9-2320-279-20).
Prepare tanker for operation (TM 9-2320-279-10).
Fill tank with fuel by performing bottom loading (TM 9-2320-279-10).
Recirculate fuel (TM 9-2320-279-10).
Change 2
