TM 9-2320-279-34-2
Cab and Body Maintenance Instructions (Cont)
b. Installation.
NOTE
The following steps apply to both sides of vehicle. Passenger
side is shown.
(1) Install bracket (1) and spacer (2) with screw (3), washer (4),
and locknut (5).
(2) Install three screws (6) and locknuts (7). Do not tighten.
(3) Install three screws (8) and nuts (9). Tighten nuts to 375 lb-ft
(509 N·m).
(4) Tighten locknuts (7).
Install bracket (10), screw (11), washer (12), and
(5)
n u t ( 1 3 ) .
(6) Install three screws (14) and locknuts (15).
(7) Install two screws (16), washers (17),
sleeves (18), springs (19), four washers (20
and 21), and two locknuts (22).
(8) Tighten each locknut (22) until each spring (19)
is compressed to 3-5/8 in. (92 mm).
(9) Install bracket (23), screw (24), washer (25), and
locknut (26).
(10) Install two screws (27), lockwashers (28), and
nuts (29).
c. Follow-on Maintenance. Install fuel tank (when
left front bracket is removed) (TM 9-2320-279-20).
END OF TASK
15-53
