TM 9-2320-279-34-2
Axles No. 3 and No. 4 Maintenance Instructions (Cont)
I
10-6. YOKE AND OIL SEAL (AXLE NO. 3 AND NO. 4) REMOVAL/INSTALLATION
(CONT).
c.
Yoke and Oil Seal Axle No. 3, Rear, and Axle No. 4 Removal.
NOTE
Manufacture 2-1/4 in. socket in accordance with Appendix B, Figure 17.
(1)
Using 2-1/4 in. fabricated socket, remove flanged nut (1).
(2)
Remove yoke (2).
(3)
Remove oil seal (3).
d.
Yoke and Oil Seal Ax/e No. 3, Rear, and Axle No. 4 Installation.
(1)
Lubricate oil seal (3) with oil. Install oil seal.
(2)
Install yoke (2) on differential shaft (4).
(3)
Install flanged nut (1) on differential shaft (4).
NOTE
To tighten yoke nut use torque multiplier and 250 lb-ft (339 N•m) capacity ratchet
end torque wrench.
(4)
Using 2-1/4 in. fabricated socket, tighten flanged nut (1) to 840 to 1020 lb-ft (1 139 to 1 393 N•m).
e.
Follow-on Maintenance.
Install propeller shaft (TM 9-2320-270-20).
END OF TASK
10-14
Change 2
