TM 9-2320-279-34-2
Frame Maintenance Instructions (Cont)
NOTE
Install wire clips and plastic cable ties as necessary.
(8)
Install strobe and worklamp wiring harness (18) to towing support (1).
(9)
Install grommet (19) in towing support (1).
(10)
Install hydraulic lines (14 and 16) through conduit (20).
(11)
Install clamp (21) over lines (14 and 16) and wiring harness (18).
(12)
Install screw (22), washer (23), and nut (24).
(13)
Install six hydraulic lines (25 and 26) on bulkhead adapters (5 and 6).
NOTE
Some vehicles have a winch clevis tie down. Do steps (13.1) through (13.5)
for these vehicles.
(13.1)
(13.2)
(13.3)
(13.4)
(13.5)
Install adhesive
tape (26.1) and
plastic (26.2).
Install eyebolt (26.3),
spacer (26.4), ratchet
and tiedown (26.5), and
nut (26.6).
Route tiedown (26.5)
over plastic (26.2) and
through opening in top
to wing support (1).
Install hook (26.7) in
eyebolt (26.3).
Use ratchet (26.8) to
tighten tiedown (26.5) in
stowed position.
Change 2
13-90.5
