TM 9-2320-279-34-2
Frame Maintenance Instructions (Cont)
13-6. LIFT BRACKET ASSEMBLIES REMOVAL/INSTALLATION (CONT).
(6) Install tube brace (16), two
spacers (17), wedge washers (18),
lockwashers (19), and screws (20).
(7) Remove lifting device from lift
bracket (1 or 21).
c. Follow-on Maintenance.
(1) Install propeller shaft on No. 1 and
No. 2 axle (TM 9-2320-279-20).
(2) Install splash guards
(TM 9-2320-279-20).
(3) Connect batteries
(TM 9-2320-279-20).
(4) Install wheels and tires on No. 2
(5)
axle (TM 9-2320-279-10).
Install winch hoist arm and
extension (TM 9-2320-279- 10).
END OF TASK
13-7. TRANSMISSION SUPPORT REMOVAL/lNSTALLATION.
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
Equipment Condition
All
TM or Para
Condition Description
Test Equipment
TM 9-2320-279-20 Fuel can stowage box
None
removed (M978).
Special Tools
Para 15-9
Cargo body floor hatch
None
removed (M977, M985).
TM 9-2320-279-20 Engine cover removed.
Supplies
TM 9-2320-279-10 Engine side panels removed.
Oil, lubricating, Item 48, Appendix C
TM 9-2320-279-20 Splash guards removed.
TM 9-2320-279-20 Generator removed (M983).
Personnel Required
Para 13-6
Lift bracket assemblies
MOS 63W, Wheel vehicle repairer (2)
removed.
References
Special Environmental Conditions
None
None
Equipment Condition
General Safety Instructions
TM or Para
Condition Description
None
TM 9-2320-279-10 Shut off engine.
Level of Maintenance
TM 9-2320-279-10 Cargo body front
Direct Support
panel removed
(M977, M985).
13-16
