TM 9-2320-279-34-1
Transfer Case Maintenance Instructions (Cont)
(7)
Turn top input shaft (1) over and install
shaft collar (8) so larger taper is down.
(8)
Install gear spacer (9), needle
bearing (10), spacer (11), and second
needle bearing.
(9)
Coat two needle bearings (10) with
grease.
(10)
Install large gear (12) over top input
shaft (1).
(11) Install spacer (13).
(12)
Press bearing (14) to seat against
spacer (13).
(13)
Install spacer (15) and piston ring (16).
(14)
Install pump drive plate (17).
NOTE
Retaining screws may be either grade 5 or grade 8.
Torque screws accordingly.
(15)
Coat threads of two screws (18) with sealing
compound and install. Tighten grade 8
screws to 88 lb-ft (119 N•m). Tighten grade 5
screws to 60 lb-ft (81 N•m).
d. Follow-on Maintenance. None.
END OF TASK
Change 3
8-33
