TM 9-2320-279-34-1
Transmission Maintenance Instructions (Cont)
c.
Installation.
(1)
Using oil seal installer, install oil seal (6) with seal lip facing rear cover (5).
(2)
Install dust shield (4) in rear cover (5), flat side first, so rear edge of shield is flush with surface
of rear cover.
(3)
Install output yoke (3) on output shaft (2).
(4)
Coat threads of output shaft (2) and retainer nut (1) with lubricating oil.
(5)
Install retainer nut (1) on output shaft (2). Tighten nut to 600 to 800 lb-ft (813 to 1085 Nm)
with lock socket.
d.
Follow-on Maintenance. Install propeller shaft (TM 9-2320-279-20).
END OF TASK
Section VII. CLUTCH ASSEMBLIES
7-15. FORWARD CLUTCH ASSEMBLY REMOVAL/REPAIR/INSTALLATION
This task covers:
a. Removal
d. Assembly
b. Disassembly
e. Installation
c. Cleaning/Inspection
f. Follow-on Maintenance
INITIAL SETUP
Models
All
Test Equipment
None
Personnel Required
MOS 63W, Wheel vehicle repairer (2)
References
None
Special Tools
Clutch spring compressor J24204-3
Collector ring installer and staking set
J24200
Equipment Condition
TM or Para
Para 7-20
Condition Description
Control valve body
removed.
Forward clutch piston inner seal protector
J24216-01
Para 7-9
Torque converter housing
removed.
PTO gear removal fixture J26899
Fourth clutch alinement fixture J24221
Forward clutch lifting bracket J33079-1
Special Environmental Conditions
None
Fabricated Tools
Shim stock, Item 2, Appendix B
General Safety Instructions
None
Supplies
Oil, lubricating, Item 45, Appendix C
Oil, lubricating, Item 46, Appendix C
Solvent, drycleaning, Item 57, Appendix C
Compound, retaining, Item 24, Appendix C
Level of Maintenance
General Support
Change 3
7-91
