TM 9-2320-279-20-2
Change 4
16-169
Cab and Body Maintenance Instructions (Cont)
a. Removal.
NOTE
·
Both roller assemblies are removed
and installed the same way. Mark
position of rollers and brackets.
·
Model B has a rubber tiedown
strap to secure fuel service nozzle
in stowage position. Do steps (1)
and (2) for Model A. Do
steps (1.1), (1.2), and (2) for
Model B.
(1)
Remove two locknuts (1),
screws (2), brackets (3),
spacers (4), long roller (5), and
two short rollers (6) from
frame (7).
(1.1) Remove rubber tiedown strap (7.1).
(1.2) Remove two locknuts (7.2),
nuts (7.2.1), eyebolts (7.3),
brackets (3), spacers (4), long
roller (5), and two short rollers (6)
from frame (7).
(2)
Remove two locknuts (8),
brackets (9), washers (10), and
long roller (11).
b. Installation.
NOTE
Do steps (1) and (2) for Model A. Do
steps (1), (2.1), and (2.2) for Model B.
(1)
Install two washers (10), long
roller (11), and two brackets (9) on
frame (7) with two locknuts (8).
(2)
Install two spacers (4), two short
rollers (6), long roller (5), and two
brackets (3) with two screws (2)
and locknuts (1).
(2.1) Install two spacers (4), two short
rollers (6), long roller (5), and two
brackets (3) with two eye
bolts (7.3), nuts (7.2.1), and
locknuts (7.2).
(2.2) Install rubber tiedown strap (7.1)
between eye bolts (7.3) to secure
fuel service nozzle in stowage
position.
c. Follow-on Maintenance.
(1)
Install V2 dust cap (para 25-38).
(2)
Close pump module rear access
doors (TM 9-2320-279-10).
END OF TASK
