TM 9-2320-279-20-2
Change 5
16-130.13
Cab and Body Maintenance Instructions (Cont)
b. Cleaning/Inspection.
WARNING
Drycleaning Solvent (P-D-680) is TOXIC and flammable. Wear protective goggles,
face shield, and gloves; use only in a well-ventilated area; avoid contact with skin,
eyes, and clothes, and do not breathe vapors. Keep away from heat or flame. Never
smoke when using solvent; the flashpoint for Type I Drycleaning Solvent is 100_F
(38_C) and for Type II is 140_F (60_C). Failure to do so may result in injury or
death to personnel.
If personnel become dizzy while using cleaning solvent, immediately get fresh air
and medical help. If solvent contacts skin or clothes, flush with cold water. If solvent
contacts eyes, immediately flush eyes with water and get immediate medical
attention.
(1) Clean metal surfaces with drycleaning solvent.
(2)
Check for cracked or broken parts and frayed or torn webbing.
(3)
Replace all damaged parts.
c. Installation.
(1)
Install upper retractable tether (1) in cab (2) with screw (3), washer (4), and locknut (5).
(2)
Install upper retractable tether (1) in cab (2) with screw (6), washer (7), bushing (8), and
locknut (9).
NOTE
Apply sealant to bracket screws on exterior of cab.
(3)
Install bracket (10) in cab (2) with two screws (11), spacers (12), washers (13), and locknuts
(14).
(4)
Install two screws (15), four washers (16), and two locknuts (17) on bracket (10).
(5)
Install upper retractable tether (1) on seat (18) with washer (19), lockwasher (20), screw (21),
and cap (22).
