TM 9-2320-279-20-2
Frame and Tire Carrier Maintenance instructions (Cont)
CAUTION
Do not bend or pull connected wires or
hoses when installing fuel-water separator
to mount. Damage to attached parts and
fuel-water separator could result.
(8)
Position fuel-water separator (21) on
tire carrier (1).
NOTE
Some vehicles have nuts, lockwashers,
washers, and screws. Others have flanged
nuts and screws.
(9)
Install four screws (22), two
lockwashers (23), ground wire (24),
three flat washers (25), three
lockwashers (26), and four nuts (27).
(10)
Close drain valve (28).
c.
Follow-on Maintenance.
(1)
Stow spare tire (TM 9-2320-279-10).
(2)
Install fuel restriction sensor (para 7-109).
(3)
Install fuel-water separator guard (para 4-10).
END OF TASK
14-17. TIRE CARRIER DECKING AND BRACKETS ASSEMBLY
REMOVAL/INSTALLATION (M983).
This task covers:
a. Removal
c. Follow-on Maintenance
b. Installation
INITIAL SETUP
Models
M983, without crane
Test Equipment
None
Special Tools
None
Supplies
None
Personnel Required
MOS 63S, Heavy wheel vehicle mechanic (2)
References
None
Equipment Condition
TM or Para
Condition
Description
Para 16-70
Slave cable hooks
removed.
TM 9-2320-279-10 Shut off engine.
TM 9-2320-279-10 Ladder removed.
Para 16-35
Stowage box removed.
Special Environmental Conditions
None
General Safety Instructions
None
Change 2
14-37
