TM 9-2320-279-20-2
Brake and Air System Maintenance Instructions (Cont)
11-33.1
AIR RESERVOIR NO. 4 AND LEFT SIDE TIRE INFLATION CONNECTOR
REMOVAL/INSTALLATION (M984E1) (CONT).
c.
Left Side Tire Inflation Connector Removal.
(1)
(2)
(3)
(4)
Loosen nut (1) and remove tube (2).
Remove quick disconnect (3).
Remove nut (4), lockwasher (5), and
anchor fitting (6) from bracket (7).
Remove nipple (8) and (9) from anchor
fitting (6).
NOTE
vehicles have two nuts, lockwashers, and
Some
screws. Others have two flanged nuts and
screws.
(5)
Remove two nuts (10), lockwashers (11),
washers (11.1), screws (12), and bracket (7)
from fender (13).
d.
Left Side Tire Inflation Connector Installation.
NOTE
Some vehicles have nuts, lockwashers, and
screws. Others have flanged nuts and screws.
(1)
Install bracket (7) on fender (13) with two
screws (12), washers (11.11,
lockwashers (11) and nuts (10).
WARNING
Adhesives, solvents, and sealing compounds can
burn easily, can give off harmful vapors, and are
harmful to skin and clothing. To avoid injury or
death, keep away from open tire and use in
well-ventilated area. If adhesive, solvent, or
sealing compound gets on skin or clothing, wash
immediately with soap and water.
NOTE
Coat all pipe threads with pipe thread sealing
compound.
(2)
Install fitting (9) and nipple (8) on anchor
fitting (6).
(3)
Install anchor fitting (6) in bracket (7)
with lockwasher (5) and nut (4).
(4)
Install quick disconnect (3).
(5)
Install tube (2) and tighten nut (1).
e.
Follow-on Maintenance.
(1)
Close drain valve (TM 9-2320-279-10).
(2)
Start engine (TM 9-2320-279-10).
(3)
Build air pressure (TM 9-2320-279-10).
(4)
Check reservoir and tire inflation connection for leaks.
(5)
Shut off engine (TM 9-2320-279-10).
END OF TASK
11-140
Change 2
