TM 9-2320-279-10-1
2-144.2
Change 8
M977 Through M985 General Operating Procedures (Cont)
2-9. PREPARE TO OPERATE VEHICLE (CONT).
(2)
Push lever (2) to left and slide
seat (3) forward or backward.
(3)
Let go of lever (2) to lock
seat in place.
(4)
Pull up lever (4) and lift
self off seat (3) to raise
seat.
(5)
Pull up lever (4) and push
down on seat (3) to lower
seat.
(6)
Let go of lever (4) to lock
seat (3) in place.
(7)
Tighten seat retaining
straps (5).
e. Operate Seatbelt (Non- FHTV Model
Vehicles Only).
NOTE
If equipped with three-point seatbelt
proceed to paragraph f. Operate
Three-Point Seatbelt.
(1)
Put seatbelt flat metal end (6)
into buckle (7) until click is heard.
(2)
Place seatbelt (8) as low on hips
as possible.
NOTE
Seatbelt does not have self-adjusting
lock. Take slack out of seatbelt by
pulling on seatbelt end.
(3)
Pull seatbelt end (9) until belt
fits snug.
(4)
To release seatbelt (8), lift top of
buckle (7) and pull out flat metal
end (6).
f. Operate Three- Point Seatbelt
(Non-FHTV Model Vehicles Only).
(1)
Put seatbelt flat metal end (10)
into interconnect (11) until
click is heard.
(2)
Pull out on comfort latch (12)
locking handle and move comfort
latch up and down strap until snug
(but not tight) fit at shoulder is felt.
(3)
To release seatbelt, push in
button on interconnect (11).
