TM 5-5420-234-14&P
5-19. WINCH HYDRAULIC TUBE (COMPRESSION FRAME) REPLACEMENT (continued).
(6) Remove ten screws (10), lockwashers (11), washers (12), five cover plates (13), five 2-piece clamps (14)
from compression frame (3). Discard lockwashers.
(7) Remove tube (4) from vehicle.
3
14
4
13
b. Installation.
12
11
(1) Position tube (4) on vehicle.
10
NOTE
Do not tighten twin clamps until all clamps are installed.
Install cable ties as required.
(2) Install tube (4) on compression frame (3) with five 2-piece clamps (14), five cover plates (13), washers
(12), ten new lockwashers (11) and screws (10).
(3) Install bulkhead fitting (6) on rear compression frame bracket (9) with bulkhead locknut (7) and
lockwashers (8).
(4) Install tube (4) on bulkhead fitting (6).
(5) Install hose (5) on bulkhead fitting (6).
5-125
