TM 5-5420-234-14&P
4-70. CAB TO JUNCTION BOX LINKING HARNESS (9-PIN) REPLACEMENT
(MODEL A ONLY) (continued).
(3) Remove grommet (4) from cab (5).
(4) Follow 9-pin cab to junction box harness (6) down through cab (5) and remove cable ties as required.
(5) Remove 9-pin cab to junction box harness (6) from vehicle (7).
7
4
~
6
5
b. Installation.
NOTE
The 9-pin linking harness is routed the same as the 24-pin linking harness.
Install cable ties in same locations as noted during removal.
(1) Route 9-pin cab to junction box harness (6) up through vehicle (7) and cab (5).
(2) Install grommet (4) in cab (5).
(3) Connect connector P3 (2) to junction box (3).
(4) Close hydraulic cabinet cover (1).
c. Follow-on Maintenance:
Install heater compartment covers (TM 9-2320-279-20).
Install cab control box (para 4-71).
END OF TASK
Change 1
4-4-591
584.5
