TM 5-5420-234-14&P
4-42. BAP TRANSLOAD ROLLER HYDRAULIC SYSTEM REPAIR (continued).
c. Installation.
NOTE
Steps 1 through 6 are for curb side only. Go to Step 7 for road-side hydraulics.
(1) Install two fittings (49) on frame (18).
(2) Install tube (44) on two fittings (49).
48
16
14
44
47
19
15
46
49
20
49
41
18
42
43
22
18
18
21
23
17
45
30
40
26
31
(3) Install nut (46), new lockwasher (47), and clamp (48) on tube (44) and frame (18).
(4) Install two screws (40), nuts (41), and new lockwashers (42) and four cushion clamps (43) on tube (44)
and frame bracket (45).
(5) Install two screws (21), new lockwashers (22), and washers (23) and manifold (17) on frame (18). Install
plug (19) and new O-ring (20) on manifold (17).
(6) Install fitting (16) on frame (18). Install fitting (15) on manifold (17). Install hose (14) on two fittings
(15 and 16).
(7) Install six screws (38) and new lockwashers (39) and mounting plate (7) on frame (18). Make sure
mounting plate (7) is installed with two small holes on top.
(8) Install two extensions (37) on two hydraulic cylinders (11).
(9) Install two hydraulic cylinders (11) on mounting plate (7).
4-501
