TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
19. BAP WINCH DOES NOT WIND IN (MODEL B ONLY) (continued).
CONTINUITY TEST
CAUTION
Electrical power must be shut off
from circuit before continuity can
be checked. Failure to comply with
this caution may result in damage
to test equipment or electrical sys-
WINCH IN
tem.
CONNECTOR
(1) Set multimeter to ohms position.
NOTE
POSITION 1
A reading of infinity indicates an
POSITION 2
open circuit.
(2) Connect multimeter between digital
controller wiring harness conector,
(J3), position "6", and winch in
J3
solenoid connector, position "1".
POSITION
36
Check multimeter for continuity.
(3) Connect multimeter between (J3),
position "36" and winch in solenoid
connector, position "2". Check
multimeter for continuity.
POSITION 6
4-4-14.1
4 42 7
Change 1
