TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
19. BAP WINCH DOES NOT WIND IN (continued).
CONTINUITY TEST
CAUTION
Electrical power must be
shut off from circuit before
continuity can be checked.
Failure to comply with this
caution may result in
damage to test equipment
P9
or electrical system.
(1) Disconnect remote control cable
from components.
(2) Set multimeter to ohms position.
NOTE
A reading of infinity indicates an
open circuit.
P8
REMOTE CONTROL
(3) Connect multimeter leads to each
CABLE
end of wire and check multimeter
for continuity. Check for continuity
between position "E" on chassis
end and position "F" on remote
control end. Also check for
continuity between position "J" on
chassis end and position "E" on
remote end.
Change 1
4-409
