TM 5-5420-234-14&P
4-12. UNIT TROUBLESHOOTING (continued).
14. MAIN FRAME DOES NOT UNLOAD IN MANUAL MODE (continued).
CONTINUITY TEST
CAUTION
Electrical power must be shut off
from circuit before continuity can
be checked. Failure to comply
with this caution may result in dam-
age to test equipment or electrical
system.
(1) Disconnect remote control cable from
P9
components.
(2) Set multimeter to ohms position.
NOTE
A reading of infinity indicates an open
circuit.
(3) Connect multimeter leads to each end
of wire, and check multimeter for
REMOTE CONTROL
continuity. Check for continuity
P8
CABLE
between position H on chassis end
and position H on remote control end.
Also check for continuity between
position J on chassis end and
position E on remote end.
4-275
Change 1
